Prepare The Hood; Measure The Installation - Broan B5630SS Manual Del Usario

INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
HOOD
efficiently.
3. Long duct
runs, elbows
and transitions
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.

MEASURE THE INSTALLATION

6"
ROUND DUCT
DECORATIVE FLUE
HOOD
3¼"
30"
TO
COOKING SURFACE
The minimum hood distance above cooktop MUST NOT BE
LESS than 30".
A maximum of 36" above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 36" are at the installer and users discretion;
providing that the ceiling height permits.
ROOF CAP
6"
ROUND DUCT
DECORATIVE
FLUE
30" 36"
TO ABOVE
COOKING SURFACE
ROOF CAP
ROUND ELBOW
WALL CAP
HOOD MOUNTING
BRACKET
1
12 / "
TO CENTER
2
OF BRACKET HOLES
36"
ABOVE
*
MODELS B5630SS • B5636SS • B5730SS • B5736SS

PREPARE THE HOOD

Unpack hood and check contents. You should receive:
1 - Hood
1 - Glass Canopy (Models B5630SS & B5636SS)
1 - Metal Canopy (Models B5730SS & B5736SS)
1 - Decorative Flue Assembly
1 - Damper / Duct Connector
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
WALL CAP
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (installed in hood)
1 - Parts Bag containing:
ROUND
8 - Mounting Screws (#8 x 3/8" Pan Head)
ELBOW
7 - Mounting Screws (#8 x 1-1/2" Flat Head)
4 - Mounting Screws (M4 x 1.0 Flat Head)
7 - Drywall Anchors
2 - Washers
4 - Decorative Washers
1 - Installation Manual
DECORATIVE FLUE
DAMPER / DUCT
CONNECTOR
4 DECORATIVE
WASHERS
8 MOUNTING
SCREWS
(#8 x 3/8"
Pan Head)
4 MOUNTING
SCREWS
2 WASHERS
(M4 X 1.0"
Flat Head)
7 MOUNTING
SCREWS
(#8 X 1-1/2"
Flat Head)
UPPER
FLUE MOUNTING
BRACKET
LOWER
MOUNTING
FLUE MOUNTING
BRACKET
BRACKET
Page 2
7 DRYWALL
ANCHORS
HOOD