Sauder Craft Armoire 158097 Manual Del Usario página 12

Step 7
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
FIXED SHELF (D) and SHELF UPRIGHT (N).
NOTE: A perforation has been provided for access through
å
the BACK. Carefully cut out the hole in the BACK for
cord management.
Place a LEVELER BRACKET (17E) over the holes in the bottom
å
edges of the ENDS (A and B). Use a hammer to drive a PROPEL
NUT (14M) through each BRACKET and into the holes in the
edges of the ENDS (A and B). Now, turn a LEVELER (18E) into
each PROPEL NUT.
NOTE: The LEVELERS are used to level the unit
å
when it is standing upright.
Cut out this hole for
cord management.
A
17E
18E
14M
Page 12
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
F
158097
1N
NAIL
(46 used in this step)
These holes must line up
over the FIXED SHELF (D)
and SHELF UPRIGHT (N).
B
www.sauder.com/services