Tabla de contenido
Publicidad
Step 10
Fasten the OUTER UPRIGHTS (L) to the PULL-OUT TOP (I).
å
Tighten four TWIST-LOCK® FASTENERS.
Fasten the PULL-OUT BACK (J3) to the PULL-OUT TOP (I).
å
Use three SILVER 2" FLAT HEAD SCREWS (57S).
These holes
must be here.
Open end
The EXTENSION RAILS
must be facing each other.
www.sauder.com/services
I
L
Open end
J3
L
158097
57S
SILVER 2" FLAT HEAD SCREW
(3 used in this step)
Page 15
Publicidad
Tabla de contenido
