Maytag SKYBOX ROOKIE Manual Del Usuario página 6

Operation
Beverage Bin
The Skybox™ Rookie™ Refrigerator is equipped with a
convenient Beverage Bin and cover on top of the unit.
The bin holds ice, water, and unopened beverage
containers, or other items as needed for storage.
Beverage Bin Cover:
1. Place finger in the small hole at the front edge of
the cover. Lift up.
2. The hinged cover will pull up, over, and down to
rest against the back of the refrigerator.
3. To remove the cover completely, open the cover
almost vertical, slide it to the side to pull the two
hinge pins out of the hinge pin holes, and lift the
cover off of the beverage bin.
Be careful not to overload the Beverage Bin.
Overloading may cause water and/or ice to overflow
the tray and spill onto the refrigerator unit. Do not
load the serving tray with more than 30 cans or
bottles. Do not let the serving tray fill with more
than 1-inch of water or more than half full of ice
cubes.
5
CAUTION
To Remove the Beverage Bin:
1. Remove any beverage containers in the Beverage
Bin. To prevent spills, if the tray is extremely full of
water and/or ice, use an ice scoop or plastic cup
to remove a portion of the load.
2. Grasp the Beverage Bin handles and carefully lift
the tray up and away from the refrigerator.
3. Discard ice and water in the sink or tub.
To Attach the Beverage Bin:
1. Hold Beverage Bin by handles and place on
top of the refrigerator, aligning the posts on the
top of the refrigerator with the indentations on the
bottom of the Bin.
2. Snap into place.
3. Rotate the holding tab on the back of the beverage
bin upwards.