Symbols; Product Description - Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador

2

Symbols

The symbols and their meaning in the manual or on the product label are
indicated below.
Generic danger.
Important safety information. Indicates operations and situations
in which the personnel involved must pay close attention.
Dangerous voltage risk.
Indicates operations and situations in which the personnel involved
must pay close attention to dangerous voltages.
Hot surfaces risk.
Indicates danger due to hot surfaces or which anyway have high
temperatures (risk of burns)
Useful information
Indicates useful information for the installation.
Refer to the Installation and use instructions.
Indicates the obligation to refer to the manual or original document,
which must be available for future use and must not be damaged
in any way.
Protective earth connection point.
Indicates the admissible temperature range.
Alternating current (AC)
Direct current (DC)
Symbol for the product disposal according to the WEEE directive,
see chapter 22.
3

Product description

The H70/200AC control unit is intended to control gate automation systems with 1 or 2 asynchronous single phase
230 V AC ROGER motors.
Ensure that the parameter A1 is set correctly. If this parameter is not set correctly, the
automation system may not function properly.
Use the same type of motor for both gate leaves in automation installations for double leaf swing gates.
ensuring that the gate leaves overlap correctly.
ROGER TECHNOLOGY cannot be held responsible for any damage or injury due to improper use
or any use other than the intended usage indicated in this manual.
recommend installing F2ES or F2S series photocells.
For further information, refer to the automation installation manual.
48