Kohler K-2684 Manual Del Usuario página 4

Lock Screw
Washer
Washer
Rear
Leg
Front
Leg
2. Install the Legs
NOTE: To protect the finished surface of the cabinet, perform
assembly tasks on a flat, padded work surface.
Remove the Door
Lay the cabinet on a flat, padded surface with the door facing up.
Remove the door to ease the installation process. Refer to the
"Door Adjustments" section of this guide.
Attach the Legs
Position the leg assemblies as shown; verify the clips are facing
each other.
Secure each leg post using two #8 x 2" panhead screws, lock
washers, and flat washers.
Install the Cross Rail
Position the cross rail above the clips between the right and left
leg assemblies (as shown).
Evenly press down on the cross rail until the clips are fully
engaged. You may need to apply slight pressure on each end
until it clicks in place.
1207228-2-A
Cross Rail
Clip
4
Clip
Kohler Co.