Operating Features - Seav LRX 2035 NEW READER Manual De Usario

OPERATING FEATURES:

Step-by-step operation:
By using either the Radio Control, Transponder, Digital keyboard, Smartphone or the low volt-
age buttons to activate the frame, you obtain the following action:
the first impulse activates the opening mechanism until the motor time expires or the opening
limit switch is reached, the second impulse closes the gate. If an impulse is sent before the
motor time expires or one of the two end runs are reached, the control unit will stop both open-
ing and closing movements. An additional control re-starts motion in the opposite direction.
Operating Mode using Radio Control,
Transponder, Digital keyboard and Smartphone:
The receiver can be combined with Radio Controls, Transponders, Digital Keyboards,
Smartphones and stores up to 120 different users.
For use with radio controls, the receiver unit is equipped with an incorporated receiver;
for use of the other devices, the desired accessory must be connected (by carefully fol-
lowing the connection diagrams described in the relative operating manuals) supplied
as optionals.
Operation with different radio control models:
Different radio control models can be programmed: store one code (1 key) for Step-by-
Step cyclic operation (Opening - Stop - Closing); store two different codes (2 keys) for
separate controls, the first for Opening and the second for Closing; store one code (3
"BeFree series" keys) for three separate controls, the first for Opening, the second for
Stop and the third for Closing.
Radio control operation with 1 Key:
Using the radio control with only one key, the following function is obtained: the first
impulse commands Opening until the motor time expires. The second impulse commands
Closing of the frame. If an impulse occurs before the motor time expires, the control
unit stops the frame. A further impulse implements the re-starting of the motion in the
opposite direction.
Radio control operation with 2 Keys:
Using the radio control with 2 keys, the following function is obtained: the first key ("Up"
associated to the Opening direction) commands Opening until the motor time expires,
and the second key ("Down" associated to the Closing direction) commands Closing of
the frame. If the Up command is given again during Opening, the control unit continues
the Opening motion, while if a Down command is given, the control unit stops motion.
The same procedure is valid during the Closing phase.
Radio control operation with 3 Keys (BeFree series):
Using the BeFree series radio controls, the following function is obtained: the Up key com-
mands Opening until the motor time expires, the Stop key commands Stop, and the Down key
commands Closing of the frame. If during opening or closing a Stop command is given, the
control unit commands the frame to stop. If during opening or closing the command opposite
the present motion is given, the control unit commands to run in the opposite direction.
Automatic closing :
The control unit closes the gate automatically without sending additional commands.
The choice of this operating mode is described in the instructions for setting the delay
Safety Device (Photocells):
The control unit allows for the connection and control of Photocells, Tyre sensors (NC).
- DS Input (NC)
Commands from the Safety Device are ignored during opening, whereas during closing
they will reverse the direction of movement.
PROGRAMMING:
SEL key: selects the type of function to be stored, selection is indicated by a flashing LED.
Repeatedly press the key to select the desired function. The selection remains active for
15
period.