Emotron VSA 23 Manual Del Usuario página 48

Remote/Local change function
Local mode
Run command via the
Frequency command
When [215]=000: only the
[212] setting has no effect.
When [215]=001: only VR on the keypad can control and [212] setting has
no effect.
Remote mode
Run command from Run menu [213] control setting
Frequency command from Frequency menu [212] control setting
Remote/Local change mode on keypad is achieved by simultaneously pressing
and . Each successive operation toggles between local and remote.
Note: The VSD must be stopped.
The display
Menu levels
The display has one row with space for three characters. Menu level is indicated
by flashing of the corresponding character. This means:
• When you are in the first level (hundreds), the left most character is flashing.
• When you are in the second level (tens), the middle character is flashing.
• When you are in the third level (units), the right most character is flashing.
Enter data
• Press the
• Use the or
• Confirm value by pressing the
Emotron AB 01-3991-11r2
key on the keypad
key to enter the editing mode.
key to enter data.
Programming instructions and menu list
or key on the keypad can control and
key.
47