Emotron VSA 23 Manual Del Usuario página 50

Table 23
Menu Function Description
External control opera-
218
tion mode
Remote keypad con-
219
trol selection
Main setup, Motor data
221 Rated motor voltage
222 Rated motor power
223 Rated motor current
224 Rated motor frequency
225 Rated motor speed
226 Carrier frequency
Main setup, Motor protection
231 Run stall-prevention
Run stall-prevention
232
level (%)
Stall prevention time
233
during run
Electronic thermal
234 relay protection for
motor (OL1)
Acceleration stall-pre-
235
vention
Acceleration stall-pre-
236
vention level (%)
Deceleration stall-pre-
237
vention
Emotron AB 01-3991-11r2
Range/ Code
000: Forward/ Stop-Reverse/Stop
001: Run/ Stop-Forward/Reverse
002: 3-wire-Run/ Stop
000: Disable (no signal loss detection)
001: Enable. On signal loss stop accord-
ing to [337]
002: Enable. Runs at the last set fre-
quency. On signal loss Stop is according to
[213] setting or Stop key on keypad.
0 to 120 (x 100 RPM)
004 to 016
000: Run stall prevention available
001: Run stall prevention unavailable
050 to 300
000: According to dec. time set in [332]
001: According to dec. time set in [239]
000: Enable motor protection
001: Disable motor protection
000: Acceleration stall prevention enable
001: Acceleration stall prevention disable
050 to 300
000: Deceleration stall prevention enable
001: Deceleration stall prevention disable
Programming instructions and menu list
Factory
Remarks
Default
000
Stop VSD
then
connect
remote
000 keypad
for
proper
opera-
tion *4
*4
*4
*4
*4
*4
010 4–16K
000
200
000
000
000
200
000
49