How To Fi Ll Rinse Aid; Loading The Rinse Aid - Teka LP2 400 Manual De Instrucciones

How to fi ll rinse aid
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The
dispenser is located on the inside panel of the door .
When the low rinse aid indicator " C " lights , you
must load rinse aid .

Loading the rinse aid

Regardless of the type of detergent dispenser
installed on your appliance, you must proceed as
indicated below when loading the rinse aid.
To open the dispenser, turn the "1" cap in an anti-
clockwise direction and then pour in the rinse
aid, making sure not to overfill. The amount of
rinse aid used for each cycle can be regulated by
turning the "2" dose adjuster, located beneath the
"1" cap, with a screwdriver.
There are 6 different settings; the normal dosage
setting is 3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage
adjuster should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjuster to a lower
setting.
C
1 2
en
9