Special Advice - Teka LP2 400 Manual De Instrucciones

Note:
Interrupt or cancel a programme in progress ONLY when absolutely
necessary.
Cancelling or modifying a cycle
A cycle that is underway can be modifi ed if it has only been running for a short time.
Otherwise, the detergent may have already been used, and the appliance may have
already drained the wash water. If this is the case, the detergent dispenser must be
refi lled ( see the paragraph entitled, " Loading the detergent ").
To modify a cycle that is already underway, follow the instructions contained in the
paragraph entitled "Reset drain function", and select the programme you wish (see
the paragraph entitled, "Switching the dishwasher ON").
1/2 Load Button
This button "I" (see" Close-up View (Control Panel) ) makes it possible to wash dishes
using only the upper rack if there are not enough dishes for a full load. This will allow
you to save on water and energy consumption.
To select 1/2 load:
Select the programme ( see the paragraph entitled" Switching the dishwaher ON")
Press the 1/2 load button " I " , 1/2 load indicator "E" lights.
Close the door and then press the start/Pause button
automatically.
To cancel the 1/2 load while underway
Press start/pause button " K " and hold it for 3
- Please keep in mind that the amount of detergent should also be adapted to the 1/2
load.
Use of "3 in 1"/ Combi-Detergent Tablets
General Advice
1. Before using these products you should fi rst check that the water hard-ness in your
supply is compatible with the use of these products as per the detergent manufacturers
instructions (on the product packaging).
2. These products should be strictly used according to the detergent manufacturers
instructions.
3. If you encounter problems when using "3 in1" products for the fi rst time then please
contact the detergent manufacturers care line (the telephone number is given on the
product packaging).

Special Advice

When using combination products, the rinse-aid and salt lights are no longer useful. It
may be helpful to select the lowest possible setting for water hardness.
18
"K", then the programme starts
seconds.
en