End Of Programme - Teka LP2 400 Manual De Instrucciones

Switching the dishwasher ON
Load the appliance and turn on the tap.
Close the door, and set On-Off button "F" to On
and then the On-Off indicator "A" light.
Press the programme button "I" to select the
programme you wish, and the corresponding
programme indicator "D" light.
Press the Start/Pause button "K", then the
d i s h w a s h e r w i l l s t a r t i m m e d i a t e l y, a n d t h e
programme indicator "D" is fl ashing.

End of programme

Six beeps will indicate that the wash cycle has finished, the programme indicator
light.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set On-Off button to Off
Open the door .
Remove dishes, etc. when they have cooled down.
Turn the water tap off.
Interrupting the programme
Open the door.
Caution!
There is a risk of water squirting out from inside the appliance. Do not
open the door fully until spray arm has stopped rotating..
If the appliance has already heated up or the hot water was switched ON and then
the appliance door opened, leave the door ajar for several minutes and then close.
Otherwise, the appliance door may open due to expansion.
Close the door. After 30 seconds the programme will start from the point it was
interrupted.
Notice:
When the appliance is already underway press the On-Off button
for 3 seconds, all of the settings will be cancelled.
en
A B
F G
D
E
K
I J
17