Teka LP2 400 Manual De Instrucciones página 21

To select "Combi-Detergent tablets" function:
1. Close the door. Select the programme and then press the Combi-Detergent button "G"
until the Combi-Detergent tablets indicator "B" light.
2. Press the Start/Pause button "K", then the dishwasher will start immediately, and the
programme indicator and the Combi-Detergent tablets indicator "B" blinks.
To cancel "Combi-Detergent tablets" function:
Follow the "Cancelling or modifying a cycle while underway" instructions.
If you decide to switch to the use of a standard detergent system we advise that you:
1. Refi ll both the salt and rinse aid compartments.
2. Switch the water hardness setting to the highest possible position and run for three
normal cycles without a load.
3. Readjust the water hardness setting again according to the conditions for your region
(For more information please refer to your instruction manual).
Warning:
Do not place the tablets in the tub or the cutlery basket as this will
result in poorer wash results. The tablets should be placed in the
detergent doser.
Notice:
The usage of 3 in 1 or similar tablets is forbidden when Rapid Wash
and Soak programmes are selected.
Reset drain function
You can use Reset drain function to stop the washing cycle under running by pressing
the Reset Button "K" for 3 seconds to reset , and the appliance will stop after a few
minutes drain phase.
en
19