BH FITNESS G233N Manual De Instrucciones página 8

FITTING THE BATTERIES.
This monitor uses two 1.5 volt R6 AA
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Figure 1, and carefully
insert the two "R6 AA" type batteries
into the battery compartment (A)
making sure that the battery's polarity
is correct (matching the battery's «+»
terminal with the «+» sign inside the
battery compartment, and the «-»
terminal with the «-» sign). Close the
cover, as shown in Figure 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Discarded batteries must
be deposited in special containers,
Figure 2.
ELECTRONIC MONITOR
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 3 minutes and will show
DATE, TIME and TEMPERATURE.
English
A.SCAN FUNCTION
In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, PULSE RATE values
every 85seconds, this value will also
be displayed flashing on the lower
section of the monitor.
2. Press the MODE key and this will
cancel the SCAN function.
B.TIME FUNCTION
This function counts up or down in
steps of one second, up to a
maximum of 99:00 minutes. Pressing
the R-set key for more than two
seconds will reset all of the values,
except those relating to personal
information.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
of speed, 3. Press the SET keys to select the
time. (1-99 minutes)
4. Begin the exercise and the time
value will begin the countdown, when
it reaches zero it will beep for 3
seconds,
selected time has elapsed, the time
value will then start counting upward.
8
mode the computer
advising you that the