Diamond ENOCLIMA 370 Manual Del Usuario página 4

Operator's guide:
1. Unpacking instructions
2. Mounting the crystal shelves
3. Internal cleaning
I
4. External cleaning
5. Connection to the mains
UK
6. Controls
7. Checking correct operation
D
8. Replacing the door's magnetic gasket
E
F
!
WARNINGS
It is most important that this instruction booklet is kept together with the appliance both for future
NL
reference and for reasons of safety. 1. Adults should operate this appliance only. Do not allow children
to use the controls or play with it. 2
P
characteristics of this appliance. . The electrical installation of the appliance should be carried out by a
qualified electrician or other competent person. . Never attempt to carry out repairs unassisted. Inexpert
S
repairs can cause serious damage and malfunction. . Assistance has to be provided by an authorized
engineer only. Always use original spare parts. . This appliance is not suitable for the storage of basic
DK
commodities not including food-stuffs. . The manufacturers of this appliance accept no responsibility for
the consequences of misuse in contravention of these safety instructions. It further reserves the right to
carry out improvements without prior notice. 8
FIN
9 . Nevere install the appliance near sources of heat,such as radiators,stoves,etc.
grills free from obstruction for at least 30 cm.
B
grills do not hang over the edges.
on the evaporator, we recommend stopping the compressor and placing the goods in special refrigerated
GR
containers,kept at the same temperature,until defrosting is completed;if this is not carried out the
compressor will continue to operate leading to a wasteful consumption of electricity and poor
CZ
performance.
least 10 cm.
EE
! Our products are for internal use only do not install outside restaurants, shops.
LV
LT
1. UNPACKING INSTRUCTIONS
CARDBOARD PACKAGE 1a
H
Remove the nails from the wooden crate with care. . Insert the forks of forklift truck between the
appliance and pallet or crate. . Lift the appliance. . Remove the pallet or crate. . Place the appliance
M
on a flat and level surface.
there is nothing left in the package before disposal.
PL
disposal (see figure 1).
SK
2. MOUNTING THE CRYSTAL SHELVES
1. Remove the shelves packed in the bottom of the cell and place them on the relative supports, keeping
them near the fluorescent tube (see figure 2).
SLO
3. INTERNAL CLEANING
1. Clean the internal surfaces and glass panels with a soft, damp sponge and a neutral detergent.
2 . Clean the tube protecting the fluorescent lamp using only a damp, soft sponge. Do not use products
containing alcohol or other solvents that could damage the tubes. . Dry with a soft cloth.
4. EXTERNAL CLEANING
1 . Use specific cleaning products generally available on the market to clean the wooden surfaces, which
should anyway be water-based emulsions, free of all solvents.
5. CONNECTION TO THE MAINS
1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. . Ensure that the supply socket has the following characteristics:
b)
earthed.
with the IEC regulations: - magnetothermal differential switch with In = nominal value as stated on the
rating plate; - Differential with Id sensitivity = 30 mA.
in the room. 4.
installation in any other environments, it will be necessary to change the cable with the appropriate type
(for example H07 VVF for external use).
placed by mistake in a horizontal position or has been turned upside down, leave for at least three hours
in the correct position before switching on the power supply
adapters and reduction adapters) (see figure 3).
. It is forbidden to modify in any way the main functions and
3
7
12 . If damp air or products to be refrigerated should cause ice to form
13 . If the appliance is not working and unused, it is indispensable to keep the door open at
Cut the strap and lift the cardboard package.
3
6. Insert the spacers into the holes on the back of the cabinet. . Make sure
2
It fulfils the requirements of the rated current as set out on the rating plate.
The connecting cable to the appliance is H05 VVF, designed for internal use. For
Operator's guide
Maintenance manual (Page 48):
1. Cleaning the condenser
2. Internal cleaning
3. Replacing the internal lights
4. Wiring diagram diagram of refrigeration unit
4
5
6
. Avoid installing the cabinet directly in line with sunlight.
11 . Ensure that the products displayed on the shelves and
2
4
8. Separate the packaging materials to facilitate
3 . Ensure that there is no danger of explosion (AD)
N.B. If during transport or storage the appliance has been
. 5. Connect the plug (do not use three-way
6
10 . Keep the ventilation
WOODEN CRATE 1b
5
7
3
a)
it is properly
c)
It complies
(A) attached