Diamond ENOCLIMA 370 Manual Del Usuario página 5

6. CONTROLS
The appliance's controls are located in the lower front part
1. Refrigeration switch : to switch on the refrigeration system.
inside the appliance. 3. Thermometer:
models only the lower compartment temperature is shown.
the appliance (upper compartment only).
point, which can be changed by pressing button
7. CHECKING CORRECT OPERATION BEFORE USE
The plug is connected.
CHECK THAT: 1.
3. The thermometer shows the desired temperature for the goods to be stored.
5. The door is closed properly.
lamps. 7. The room temperature does not exceed that in which the appliance is designed to work
normally, i.e. +30°C, 55% r.h. (climatic class 4).
overloading the shelves and sufficiently wide gaps are left to allow cold air to circulate correctly.
8. REPLACING THE DOOR'S MAGNETIC GASKET
1. Open the door. 2. Take hold of the magnetic gasket and pull it out of the frame.
gasket and press it firmly down all around (see figure 5).
Operator's guide
to display the temperature in the appliance.
a) Press button
6 "UP" or button
The refrigeration unit switch is switched on (green light on).
2.
6. The appliance is not exposed to direct sunlight or to high-powered
8. The compartments are correctly loaded without
7
(A) and inside the cell (B)
2. Light switch: to switch on the light
4. Thermostat : to adjust the temperature in
5 "SET or P" once to display temperature set-
7 "DOWN" (see figure 4).
4. The lights are on.
3.
(2TV only).
N.B: in the 2TV
Insert the new
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO