Teka STROHM Icon TK Manual Del Usuario página 21

PRODUCT GUARANTEE / INSTALLATION NORMS
For a better drainage, during the installation it is recommended to raise the shower tray
5 mm on the opposite side where the shower waste is.
9 - END OF WORK
● In the final plated and walls grouted process, the tray must be protected to avoid
possible concrete stains of cement or grout that could leak.
★ If this would happened they must be rapidly cleaned with wet sponge before
it dries out. Otherwise the subsequent cleanse would be very difficult even
harming the tray when using very corrosive products or metallic tools and/
or scouring pad which are not advisable.
★
Special care when cleaning walls from exceeding concrete on the joints
because in many occasions products like acids cement removers or etching
are used. They leak and can remain on the tray for a long time being able to
damage the outer layer because though it stands these products it is only
for short periods. They must be rinsed and cleaned rapidly.
★
Never use the shower tray as a dump of the work materials especially
concrete that can be stuck to the shower tray or waste generating important
problems.
➢ All damages caused for not following these indications, they are not
converted by the guarantee of the product.
IMPORTANT
9