Instructions For Maintenance; Reminders For The Maintenance Technician; Commissioning; Troubleshooting - ALI PROXE70 Instrucciones Para Instalación, Uso Y Mantenimiento

REMINDERS FOR THE MAINTENANCE TECHNICIAN

The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
•
Read this manual carefully. It provides important
information for safe installation, use and maintenance
of the appliance.
•
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
•
Installation, conversion to a different type of gas
and appliance maintenance must be carried out by
qualified technicians authorized by the manufacturer,
in compliance with current safety standards and the
instructions given in this manual.
•
Identify the specific appliance model. The model
number is detailed on the packaging and on the
appliance data plate.
•
The appliance must be installed in a well-ventilated
room.
•
Do not obstruct any air vents or drains present on the
appliance.
•
Do not tamper with appliance components

COMMISSIONING

Following installation or any maintenance operations, check
appliance operation. In the event of any malfunction, consult
the next paragraph "Troubleshooting".
ELECTRICAL APPLIANCES
Switch on the appliance as directed in the instructions and
reminders for use given in Chapter "INSTRUCTIONS FOR
USE" and check:
•
The current values of each phase.
•
The correct operation of the heating elements.

15. TROUBLESHOOTING

ELECTRIC POTATO WARMER

The appliance does not heat.

Instructions for maintenance

Possible causes:
•
Temperature thermostat defective.
•
Heating elements defective.
Heating cannot be adjusted.
Possible causes:
•
Temperature thermostat defective.

16. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS

•
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
•
After replacing an electrical system component, check
it is correctly wired.
ELECTRIC POTATO WARMER
Replacing the heating element and the indicator light.
•
Remove the control panel.
•
Remove and replace the component.
•
Re-assemble all parts. For assembly, proceed in
reverse order.
Working thermostat replacement
•
Remove the control panel.
•
Remove the bulb from its seat on the well.
•
Remove and replace the component.
•
Re-assemble all parts. For assembly, proceed in
reverse order.

17. CLEANING THE INTERIOR

•
Check the condition of the inside of the appliance.
•
Remove any built-up dirt.
18. MAIN COMPONENTS ELECTRIC POTATO
WARMER
•
Working thermostat
•
Heating element
•
Indicator light
•
Control knob.
23