Dimplex SCANDIC Manual De Instrucciones página 4

Controls: See Fig. 2
Three switches provide a choice of heat settings. A switch
is in the ON position when the side with the markings on
(i.e. I, I, or II) is pushed in.
Switch 1 (I)
Controls the electricity supply to the heater
and flame effect.
Note: This switch must be in the ON (I)
position for heater to operate with or
without heat.
Switch 2 (I)
Provides 1 kW heat output
Switch 3 (II)
Provides 2 kW output with switch 2
Thermostat (T) - see Fig. 3
In order to maintain a certain room temperature, set the
controller to 'max.'. Operate the appliance at full power
until the required room temperature is reached. Set back
the thermostatic controller until the appliance switches off
with an audible 'click'. This temperature will be kept almost
constant by the thermostatic control switching on and off
automatically. Please note that the appliance can only
be switched on when the thermostat setting is higher than
the room temperature.
Remote Control - See Fig. 4
The maximum range of use is ~ 5metres.
NOTE: It may take a short time for the receiver to respond
to the transmitter.
NOTE: The receiver for the remote control's location is
indicated by the symbol shown in Fig.1, aim the remote
control in this direction when inputting commands.
Do not press the buttons more than once within two
seconds for correct operation.
Battery Information - See Fig. 4
1. To activate the remote control remove the clear battery
isolation strip at the base of the remote control, which
is used to ensure your remote control reaches you fully
charged.
2. To replace the remote control battery, turn over the
remote control, and follow the diagram embossed on the
remote control.
3. Only use CR2025 or CR2032 size of batteries.
Fitting
NOTE: Tipping restraint kit is only supplied with suites.
WARNING: FALLING OR TIPPING APPLIANCES CAN
CAUSE INJURY OR DEATH OF YOUNG CHILDREN, PLEASE
ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON
THIS PRODUCT.
WARNING: THE APPLIANCE IS PROVIDED WITH A TIPPING
RESTRAINT, THIS RESTRAINT IS NOT A SUBSTITUTE FOR
PROPER ADULT SUPERVISION. THIS RESTRAINT MAY PROVIDE
PROTECTION AGAINST TIPPING FURNITURE. DO NOT ALLOW
CHILDREN TO CLIMB ON FURNITURE. FAILURE TO DETACH
THIS RESTRAINT BEFORE MOVING FURNITURE MAY RESULT IN
INJURY AND DAMAGE.
This product is provided with a 'Tipping Restraint Kit' as
shown in Fig 5, to prevent the product accidentally tipping
over. Fitting Instructions are supplied with this kit please
follow these instructions carefully.
Thermal Safety Cut-out
The built-in overheat cut-out, switches off the appliance
automatically in the event of a fault! Should this occur
switch off the appliance or disconnect the mains plug
from the socket.
Remove any obstructions which may have caused the
overheating. After a short cooling down phase, the
appliance is ready for use again! If the fault should occur
again, contact your local dealer!
WARNING: In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched
on and off by the utility.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) lamps. These
LED lamps are maintenance-free and should not require
replacing during the life of the product.
Cleaning
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass viewing screen should be
cleaned carefully with a soft cloth.
DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be
used to clean the outlet grille of the fan heater.
WARNING: do not operate the product without the grille
and outer glass in position as this may effect the operation
of the heater.
Recycling
At the end of the electrical products useful life
it should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice in your country.
After Sales Service
Should you require after sales service or should you need
to purchase any spares, please contact the retailer from
whom the appliance was purchased or contact the
service number relevant to your country on the warranty
card.
Please do not return a faulty product to us in the first
instance as this may result in loss or damage and delay
in providing you with a satisfactory service. Please retain
your receipt as proof of purchase.