Kenmore 721.33189 Manual Del Propietário página 9

Extension
Wand
Remove the extension wand from its storage
position.
Remove the crevice tool from its storage
position in the wand. Attach the extension wand
onto the open end of the hose.
Add the crevice tool to the end of the wand by
inserting and twisting slightly.
The crevice tool doubles as another wand,
because the dusting brush/upholstery tool will
fit onto its tip, allowing for maximum cleaning
reach. The brush/tool may also be attached
directly to the extension wand.
Wand
Crevice
Tool
Jsting brush has two options. When the
front brush is removed the remaining part can
be used as an upholstery tool.
Upholstery
Tool _"--. _ r,_
CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching. Trying to reach
beyond the hose stretch capability
could cause the cleaner to tip over.
TO STORE ATTACHMENTS
Remove dusting brush/upholstery tool from
wand. Snap into its storage location.
Remove crevice tool from the wand by twisting.
Remove the extension wand from the hose.
Twist the wand and pull from the hose end.
Place the crevice tool down into the extension
wand. Snap wand into its storage location.
Be sure the unit is turned off. Reinsert the hose
fully into hose coupling from which it was
removed. Press firmly to assure connection.
WARNING
Personal Injury Hazard
DO NOT place hands or feet
underneath the unit when inserting the
hose. The agitator revolves rapidly
when the vacuum is turned on.
-9-