Klarstein 10031935 Manual Del Usuario página 18

EN
18
automatically confirms to work in current temp setup. LED screen operating in time
mode.
Note: Set low temperature for thin/small pieces of food or for a small load of food. Set
high temperature for drying thick/big pieces of food and large loads. The thermostat
can also be used to decrease the temperature as the food is near the end of its drying
cycle making it easier to control the final moisture level in the food.
5. During drying process, you can change or check the drying time. Press the "TIMER"
button first, then press the UP or DOWN button. Press "TIMER" button, you can
check the setting time.
6. During drying process, you can change or check the drying temp. Press the "TEMP"
button first, then press the UP or DOWN button. 5 seconds after finish changing or
checking, LED screen changes to time mode.
7. During drying process, press the power button, all functions will be paused. Screen
no display.
8. In standby mode, you can press the power button directly to get into default mode
( TIME : 10 hours TEMP: 70 °C). You also can change the drying time and temp if
needed.
Function buttons as below:
9. When the set time counts down to "0:00", the heating element stops working first.
The fan will continue running for 10 seconds and the buzzer rings 20 times "beep"
sound (1 time/second). The LED screen display signal "End" means finish drying.
Note: Make sure that the fan base is always in place when operating the dryer. If you
do not have time to dry all the food in one day, you can dry them the next day. In
this case, you should store the food in a container/polyethylene bag and put it in the
freezer.
10. Unplug the unit from the power point.