Brill 1000 EF Manual De Usario página 23

Elettrico
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 64
or if the repairs were not
carried out at a service centre
authorised by the manufacturer
Fault
Motor not running.
Cutting lines disappear
into line reel.
Cutting line cannot be
lengthened.
10. Instructions for Correct Use, Safety Instructions
Check your Electric
A
Strimmer before and
after each use
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and/or if the cutting device is
damaged or worn. Never
disable safety devices.
Check the work area before
starting work. Remove any
foreign bodies present (e. g.
stones, branches or bones).
Check for foreign bodies whilst
working.
Always wear strong shoes and
long trousers whilst working.
Do not work barefoot or in
lightweight sandals.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools
replaced by Brill Service or
your authorised specialist
dealer.
or by an authorised specialist.
The same applies to additional
parts and accessories.
Possible Cause
No power supply.
Line reel not installed properly.
Cutting line is used up.
Cutting line is trapped.
Reel installed incorrectly.
Use /
A
Responsibility
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
Powered equipment can
cause serious injuries! You are
responsible for safety in the
area where you are working.
Never start the equipment whilst
tilted – risk of injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Only work in daylight or with
adequate artificial lighting.
Ensure that you are standing
safely and on firm ground,
even on a slope. Work across
the slope, never up and down.
Do not work on excessively
steep slopes. Be careful if you
are going backwards, risk of
stumbling!
Remedy
Check power is available.
Remove line reel and
install again
(see Point 8 Maintenance ...).
Install new line
(see Point 8 Maintenance ...).
Remove line reel, unwind
line and roll up again
(see Point 8 Maintenance ...).
Remove / install line reel
(see Point 8 Maintenance ...).
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when
transporting it over surfaces
other than grass and if you
are transporting the equipment
backwards and forwards to
the work area.
Never use the machine with
damaged protective devices or
without protective devices.
When starting or operating the
starter switch take care as
stipulated by the manufacturer's
instructions. Ensure that your
feet are far enough away from
the cutting tool.
Keep your fingers and feet
away from the cutting tool!
If you strike an obstacle when
working, please disable the
machine. Unplug from the
mains. Remove the obstacle,
check the equipment for any
damage and have it repaired
if necessary.
GB
23

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido