Reggiani 5001 Manual De Usario página 6

GENERAL RECOMMENDATION
Indoor lighting fixtures, suitable for direct mounting on
normally inflammable surfaces
Protection class IP20 unless otherwise indicated on the
nameplate.
/
o HIGH VOLTAGE (above 1000V AC and 1000V
The number enclosed in the symbol
minimum distance in metres at which the object to be
illuminated can be placed. Such distance is measured along
the optical axis of the lighting fixture from the lamp side to the
nearest object lit up.
Photosensitive objects, if exposed to the action of sunbeams or
artificial light sources can bleach.
In order to increase security and exposure duration, it is
advisable to use UV-protected-lamps and/or to replace the
luminaire protection glass with anti-UV-filters.
Attention: The effectiveness of the anti-UV-filter depends on the
illuminance level (lux), the distance from the light source, the
exposure duration and light sensitivity of the individual objects.
Reggiani Spa Illuminazione does not accept any responsibility
for possible deterioration of exposed objects.
In the case of damage or breakage to the safety shields in the
luminaire
be replaced (with original shields to be ordered from Reggiani
Spa Illuminazione) before proceeding to switch on the
luminaire again.
Owing to the high operating temperatures of the light sources,
it is advisable only to perform work on fixtures at room
temperature.
INSTALLATION
- Disconnect from mains.
- Fasten mounting bracket
mounting only for power ratings of 400W).
- Remove the cover of the component housing
screw
- Attach the fixture to the bracket by making it slide in the
special guides as shown in the drawing and lock with
screw
- Connect the yellow/green earth (ground) lead of the fixture
to the earth terminal
- Connect the fixture to the mains through relative terminal
using cables with characteristics no lower in rating to type
H05 - VVF with minimum cross section of the conductors
1mm (max 2.5 mm
2
(earth) , (neutral) N.
ENGLISH
(protective glass or UV filters), they must
/ bis)
on the mounting bracket
) making sure they match with (phase) L,
2
6
.
to the wall/ceiling (wall
√
2 DC).
indicates the
by loosening
.
SPACE LIGHT