Before Use - Casals VNC50 Manual De Uso

intended for household use only.
- This appliance is not a toy. Children should
be supervised to ensure that they do not play
with the appliance.
- This appliance is intended for adult use.
Ensure that this product is not used by the
disabled, children or people unused to its
handling.
- This appliance should be stored out of
reach of children and/or the disabled.
- Do not expose the appliance to extreme
temperatures.
- Keep the appliance in good condition.
Check that the moving parts are not
misaligned or jammed and make sure
there are no broken parts or anomalies that
may prevent the appliance from operating
correctly.
- Keep the cutting tools sharp and clean.
- Let the appliance running with no load
for 30 seconds in a safe position. If you
notice serious vibration or other defects stop
the appliance immediately. Then check the
problem and /or proceed as we describe on
Anomalies and Repair clause.
- Always check the workpiece before
operation and remove any obstructions such
as nails, staples, screws, string, rags, cloths
and other debris.
- Check the position of power cables before
commencing work ensuring they are well
away from the work area.
- Keep hands and other body parts well away
from the work area whist the tool is in use.
Service:
- Make sure that the appliance is serviced
only by specialist personnel, and that only
original spare parts or accessories are used
to replace existing parts/accessories.
- Any misuse or failure to follow the
instructions for use renders the guarantee
and the manufacturer's liability null and
void.
Instructions for use
Always be sure that the tool is switched off
and unplugged before carrying out any work
on the tool.

Before use:

- Make sure that all the product's packaging
has been removed.
- Prepare the appliance according to the
function you wish to use:
Fitting the accessories (Fig.2)
- Unplug the appliance from the mains.
- Loosen the set off screws (F) using the
Allen wrench (I)
- Slide the saw blade up to the stop in the
saw blade holder (J)
- Make sure that the back of the saw blade
engages in the slot of the guide roller (G)
- Tighten the set of screws (F) firmly.
- Regularly check that the saw blade is
fastened firmly. If necessary fasten de set of
screws (F). Only carry out this operation when
the machine is unplugged.
Use:
- Before connecting the power cord to the
mains power supply ensure the switch is in
the off position.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off
switch (A)
- Always keep the base flat against the
workpiece. Failure to do so may cause a
blade breakage resulting in a serious injury.
- Allow the jig saw to reach it's maximum
speed before commencing work
Locking button (fig 1):
- To activate this function press button (B)
while holding down the start-up switch (A).
- To deactivate this function press the start-
up (A) switch right down.