Tabla de contenido
Publicidad
Basic operation of Setup Wizard
SPEAKER CONNECTION
Please select the speaker
configuration to be used.
5.1ch
7.1ch
Others
7.1ch adds 2 more speakers
Move to the item that
to 5.1ch, for enhanced
surround.
you want to configure
Select
Enter
ui
using
.
SPEAKER CONNECTION
Please select the speaker
configuration to be used.
7.1ch is selected for speaker system.
5.1ch
Select "Yes" to confirm.
7.1ch
Yes
Others
Move to the item that
7.1ch is the most popular
surround system.
you want to configure
Select
Enter
o p
using
.
SPEAKER CONNECTION
Please connect the
speakers.
Location :Front Left
Terminal :FRONT L
Press [ENTER] for next
connection.
Enters the selection.
Select
Next
SETUP WIZARD
You will now verify speaker
Do you wish to stop and exit wizard?
connections and calibrate
the system, which will
provide the highest playback
You can restart the setup wizard
quality.
anytime using the on screen menu.
Select "Next" to start.
Returns to the start of
Next
each setting.
Yes
Skip "Section1"
or
Select
Enter
Cancels the Setup
Wizard.
SVENSKA
NEDErlANDS
1
Insert the main unit power plug into the wall
socket.
Back to TOP
RETURN
To household power outlet
(AC 230 V, 50/60 Hz)
No
2
Press
ZONE SELECT
Back to TOP
RETURN
(MAIN ZONE).
Switch the zone mode
Ready to connect
J
Lights
Back to TOP
RETURN
• This remote control can be operated in three separate zones, MAIN
ZONE, ZONE2 and ZONE3.
• Set the remote control to MAIN ZONE to operate the Setup
Wizard.
Section
When power is switched to standby
Section
STANDBY
X
Press
(
).
No
GPower indicator status in standby modeH
Exit
RETURN
• Normal standby : Off
• When "HDMI Control" - "Control" (vm
page 108) is set to "ON" : Red
• When "Network Standby" (vm page
112) is set to "ON" : Red
NOTE
During power standby, a minimal amount of power is consumed. To
totally cut off the power, remove the power cord from the power
outlet.
ESpAñol
itAliANo
Getting Started
3
• This remote control is a preset remote control that can be used to
control connected devices.
4
Power cord (supplied)
to switch the zone mode to J
5
To start the Setup Wizard again after exiting it, select "SETUP
WIZARD" in the menu (vm page 84 "Menu map").
FrANçAiS
DEutSch
Press
AMP
to set the remote control unit to AMP-
operation mode.
Switch the AMP-operation mode
Z
Press
ON
(
) to the this unit.
The power switches on, and the Setup Wizard start screen is
displayed on the television screen.
Power on
SETUP WIZARD
This wizard assists
1.Language Select
connection and setup
2.Speaker Connection
of receiver step by step
using cursor, enter or
3.Speaker Calibration
return keys on remote.
4.Source Setup
Press [ENTER] to start.
5.Remote Setup
6.Network Setup
Start
Complete
Enter
Exit
RETURN
ENTER
Press
.
Start the Setup Wizard.
Setup Wizard has started.
Please follow the message on screen.
ENGliSh
5
Publicidad
Tabla de contenido
