Setup Wizard; Source Setup; Network Setup - Denon AVR-3312 Manual Del Usuario

ENGliSh DEutSch

SETUP WIZARD

When preparations are complete, start the Setup Wizard.
Use the Setup Wizard to perform connections and settings as shown in the following steps. Perform the operations as described in the
instructions on the screen. You can skip or cancel at each section if necessary.
1
Language Select
Set the language for the instructions on
the television screen.
These settings can be changed in the following menu
even after setting the Setup Wizard (vm page 118
"Language").
2
Speaker Connection
Connect the speakers for surround sound.
NOTE
Connections for speakers other than 7.1 channel or 5.1
channel speakers cannot be set using the Setup Wizard.
Select "Others", and then select "Skip" in "2. Speaker Connection" to proceed to "3. Speaker
Calibration". (For details on the setting method, see m page 59 "Speaker installation/connection
(Advanced connection)".)
3
Speaker Calibration
Configure the settings for your speakers,
and for the optimum surround sound for
your room.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 21 "Set up speakers (Audyssey ® Auto Setup)").
4
FrANçAiS itAliANo ESpAñol
LANGUAGE SELECT
Please select the language for the on screen menu.
English
Deutsch
Français
Select Enter
RETURN
SPEAKER CONNECTION
Please select the speaker
configuration to be used.
5.1ch
7.1ch
Others
7.1ch adds 2 more speakers
to 5.1ch, for enhanced
surround.
Select Enter
RETURN
SPEAKER CALIBRATION
For preparation, the setup
microphone which included
in the box is required.
Please connect the
microphone connector to
the SETUP MIC jack on
1 2 3 4
front panel.
RETURN
NEDErlANDS SVENSKA
4

Source Setup

Set the connecting terminals for each
device to be set, and connect to the
terminals.
Back to TOP
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 90 "Input Assign").
5
Remote Setup
Configure the settings so that devices
connected to this unit can be operated
using the provided remote control.
Back to TOP
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 116 "Remote Setup Guide").
6

Network Setup

Configure to playback audio files saved
onto a computer or Internet radio.
These settings can be changed in the following menu even after setting the Setup Wizard
Back to TOP
(vm page 110 "Network Setup").
SOURCE SETUP
Please select device.
Source BD
Device Blu-ray Disc player
Player
Video
Select
REMOTE SETUP
Please select the device you want to control.
Blu-ray
CABLE
CABLE/PVR
CD
CD Recorder
DVD
DVD Recorder
HD DVD
Select
NETWORK SETUP
Please connect LAN cable to
ETHERNET port on rear panel
of receiver, and other side of
cable to network router.
When connection is complete,
press "Next" to continue.
Next
This completes the Setup Wizard.
Enter Back to TOP
RETURN
IPTV STB
PVR
SAT
SAT/PVR
TV
TV/DVD
TV/VCR
VCR
Enter
Return
RETURN
Enter Back to TOP
RETURN