Hilti DX 6-GR Manual De Instrucciones página 17

6.6 Driving the X-FCP checker plate fasteners
1. Drill or punch the holes in the checker plate.
Observe the following minimum dimensions and distances:
A = 18-20 mm (0,70''-0,7'')
B ≥ 25 mm (≥ 0,98'')
2. Drive the threaded stud through the predrilled or punched hole.
3. Position the X-FCP retaining flange.
4. Follow the instructions in the installation instructions of the fastener.
6.7 Driving the X-GR grating fasteners
1. Insert the grating fastener into the fastener guide.
2. Drive the grating fastener through the grating into the supporting steel.
3. Follow the instructions in the installation instructions of the fastener.
6.8 Resetting the cleaning indicator
The cleaning indicator consists of 5 bars. Each bar stands for 500 fastenings.
The cleaning indicator is designed to indicate the correct cleaning intervals when the following
cartridges are used:
• DX 6 cartridge titanium-gray
• DX 6 cartridge, black
▶ Press the operating button at the display and hold it down for 10-12 seconds.
▶ The cleaning indicator is reset.
7 Troubleshooting
WARNING
Risk of explosion! Cartridges may fire (explode) if handled improperly.
▶ Do not use force to remove cartridges from the fastening tool or the magazine strip.
WARNING
Hazard due to hot surfaces! The fastening tool can become hot in use.
▶ Wear protective gloves.
7.1 Fastening tool jams and does not extend
WARNING! If it jams in the compressed state, the fastening tool might be loaded with the safety off.
1. Keep the fastening tool pressed against the work surface for at least 10 seconds and trigger the fastening
tool again.
2. Lift the fastening tool away from the working surface.
▶ Be sure not to point it toward yourself or other persons!
3. Try to pull the fastener guide to its initial position by hand.
▶ Take your hand off the trigger and do not hold your hand in front of the muzzle!
4. Immediately pull the cartridge strip out of the fastening tool.
If the cartridge strip cannot be removed, allow the fastening tool to cool down sufficiently under
observation. Make sure that the fastening tool is not pointed at yourself or other persons while it
is cooling down.
Contact Hilti service.
5. Service the tool. → page 11
*2253454*
11
10
2253454 English 9