Technical Data; Preparations At The Workplace - Hilti DX 6-GR Manual De Instrucciones

4

Technical data

WARNING! Always remove the cartridge strip whenever work is interrupted. In this way you avoid
deformation of the plastic strip and the risk of injury due to self-firing in an overheated fastening tool.
When you work at the maximum fastener driving rate, allow the fastening tool to cool down after one hour of
constant work.
Weight
Length (fastening tool)
Recommended maximum fastening
rate
Required contact pressure
Compression stroke
Ambient temperature (storage and
use)
4.1 Bluetooth
Frequency
Maximum emitted transmission power
5

Preparations at the workplace

▶ Before you start driving fasteners, always check that you are using the correct combination of fastener
guide, piston, fasteners and cartridge.
▶ Before commencing work, check that all safety devices are fitted and that they are functioning correctly.
In order to ensure faultless operation of the fastening tool, all parts must be fitted correctly and must
meet the necessary requirements.
5.1 Assembling the fastening tool
1. Make sure that there are no cartridge strips in the fastening tool.
2. Bring the arrow marks into alignment and insert the exhaust gas piston return unit into the housing.
3. Insert the fastener guide centered into the exhaust gas piston return unit.
4. Fit the piston.
5. Fit the buffer onto the fastener guide.
6. Insert the fastener guide centered and not tilted into the exhaust gas piston return unit.
7. Turn the fastener guide clockwise until it engages.
▶ The fastener guide is locked.
6 Operation
WARNING
Hazard due to hot surfaces! The fastening tool can become hot in use.
▶ Wear protective gloves.
WARNING! If resistance is unusually high when you insert the cartridge strip, check whether the cartridge
strip is compatible with this fastening tool.
Observe the safety instructions and warnings in this documentation and on the product.
*2253454*
DX 6-GR
3.42 kg
(7.54 lb)
491 mm
(19.3 in)
700 rev/h
174 N ... 200 N
(39 lb ... 45 lb )
f f
19 mm
(0.7 in)
−15 ℃ ... 50 ℃
(5 ℉ ... 122 ℉)
3
2253454
2,400 MHz ... 2,483.5 MHz
−27.2 dBm
English 7