Know Your Unit; Assembly Instructions - CubCadet BP226 Manual Del Operador

KNOW YOUR UNIT

Suspension System
Shoulder Support
Shoulder Support Buckle
On/Off Switch
Throttle Grip
Cruise Control
Trigger
Nozzle
Blower Tube

ASSEMBLY INSTRUCTIONS

ASSEMBLING THE BLOWER TUBE
WARNING:
To avoid serious personal injury
and damage to the unit, shut the unit off before
removing or installing the blower tubes.
Installing the Flex Tube
1. Place a hose clamp over the end of the Flex Tube (Fig. 1, A).
2. Slide the end of the Flex Tube with the clamp on it over the
elbow tube (Fig. 1, B).
3. Tighten the screw on the hose clamp to secure the Flex Tube
to the elbow tube (Fig. 1, C).
Installing the Upper Blower Tube
1. Place a hose clamp over the other end of the Flex Tube (Fig.
2, A).
2. Slide the end of the hose with the clamp on it over the top
end of the upper blower tube (Fig. 2, B).
3. Tighten the screw on the hose clamp to secure the Flex Tube
to the upper blower tube (Fig. 2, C).
Installing the Lower Blower Tubes and Nozzle
1. Align the bump slot on the end of the first lower blower tube
with the bump on the bottom end of the upper blower tube
(Fig. 3, A).
2. Insert the bump on the upper blower tube into the bump slot
on the tube extension (Fig. 3, A).
3. Twist the extension tube clockwise around the upper blower
tube until the handle tube bump locks into place (Fig. 3, B).
4. Align the bump slot on the top end of the nozzle with the
bump on the bottom end of the second lower blower tube
(Fig. 4, A).
5. Insert the bump on the second lower blower tube into the
bump slot on the nozzle (Fig. 4, A).
6. Twist the nozzle clockwise around the second lower blower
tube until the nozzle bump locks into place (Fig. 4, B).
Starter Rope
Air Filter Cover
Handle
Fuel
Cap
Choke Lever
Stand
Muffler
Primer Bulb
Fuel Tank
B
C
A
Fig. 1
C
A
B
Fig. 2
A
Fig. 3
A
Fig. 4
The completed blower tube should look like Figure 5.
Elbow Tube
Throttle Cables
Upper Blower Tube
On/Off Switch
Lower Blower Tube
WARNING:
blower tube are locked in place or firmly installed.
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables
(Fig. 6) as shown, making sure not to crimp the cables.
Adjusting the Throttle Grip
WARNING:
to adjust. This may cause the throttle cables to
disconnect from the throttle grip or the engine.
1. Move the throttle grip to a location on the upper blower
tube that is comfortable for you (Fig. 7).
2. Using a Torx T-20 Torx screwdriver, tighten the two screws
at the bottom of the throttle grip (Fig. 8).
A
Fig. 7
B
B
Hose Clamp
Flex Tube
Hose Clamp
Throttle Grip
Cruise Control
Nozzle
Fig. 5
To avoid serious personal injury, make sure that all four parts of the
Zip Tie
Do not rotate the handle clockwise
Throttle Grip
Upper Blower Tube
Zip Tie
Fig. 6
Fig. 8
5