Bosch 0 684 400 703 Instrucciones E Manejo página 20

0 en
..4. Operation

Cold Start Current:
Current as indicated on the battery. Use
keys
the
the current to between 50 Ampere and
1550 Ampere.

Batt. Standard
indicated on the battery. Use the
and  to select from the 5 different stan-
dards for batteries:
$
DIN (50 A to 900 A)
$
IEC (50 A to 1000 A)
$
SAE (85 A to 1550 A)
$
EN (80 A to 1500 A)
$
JIS (Japanese Industry Standard)

Battery temperature
 to set the battery temperature
0 °C or greater than 0 °C.
only the temperature of the battery shall
be assessed.
i
An important precondition for the battery
test is the entry of the standard and the at-
tendant cold-start current. Correct input is
essential to reliable test results.
i
Batteries can have a 9-digit number imprin-
ted on the battery casing. The last three
digits indicate 1/10 of the Cold Start Cur-
rent according to the EN battery standard.
Example: 544 059
i
Switch off all consumers in the car before
conducting the battery test and remove the
ignition key.
1 689 979 868 (2005-10-07)
Enter the Cold Start
 and  to adjust the value for
: Enter the Batt. Standard
keys
: Use the
less than
Please note that
036 = 360 Ampere

keys
 and
i
i
The Battery-Test can be started once all the
parameters have been set. The results from
the Battery-Test provide the following infor-
mation:

Voltage

Start Capacity

Overall battery condition in the form of
text:
$
Good battery
$
Recharge battery
$
Recharge battery / Repeat Test
$
Batt. recharge urgent
$
Battery unserviceable
$
Check input
BATTEry-TEST
TEST rESuLT
VoLTAgE:
STArT CAPACiTy:
BATTEry:
300A DiN
The Start output indicates the ratio of the
battery's measured cold-start current to the
entered cold-starting current. The start out-
put may exceed 100 %.
The test code is automatically generated du-
ring the battery test and serves for evaluating
warranty claims. The test code is printed out
with the printer printout.
The following messages can be displayed in
the event of problems with the Battery-Test:

Malfunction at U-Batt
Turn the engine / radio / consumers off

Contact-making problems
Check the plus terminal / Check the minus
terminal

Check parameters
0 684 400 703
12,91V
105%
gooD
>0°C
Robert Bosch GmbH