sunjoe SPX3001 Manual Del Operador página 12

Storage
Hose reel
1. Unlock the hose reel by pulling out on the handle out
(Fig. 17).
Fig. 17
2. Turn the handle counterclockwise to wind the hose
(Fig. 18).
Fig. 18
3. Wind the hose until you reach the hose's end.
4. Push the handle in to lock the reel.
m
CAUTION!
Always store your pressure washer in a
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from all hoses, the pump, and the
detergent bottle before storing.
m
recommended to prevent cold weather damage during storage
over the winter months.
Winterizing + long-term storage
If you must store your pressure washer in a location where
the temperature falls below 32ºF (0ºC), you can minimize the
chance of damage to your machine by utilizing the following
procedure:
• Disconnect all water connections.
• Turn on the machine for a few seconds until the remaining
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does
• Do not store near a furnace or other sources of heat that
Hose reel handle
• Operate the pressure washer with non-corrosive/non-toxic
m
out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left in the
system before using it again.
Maintenance
m
disconnect the plug from the power supply socket.
1. To ensure good performance, check and clean the water
Hose reel handle
12
CAUTION!
The use of a pump protector is
water in the pump exits. Turn off immediately.
not reach freezing temperatures.
may dry out the pump seals.
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
WARNING!
Before reusing, completely flush the unit
CAUTION!
Before working on the pressure washer,
inlet filter (Fig. 19). Remove the pre-filter and water inlet
filter and rinse with warm water to prevent any foreign
matter from clogging the pump (Figs. 20 – 21).
Fig. 19
Garden hose adapter
Pre-filter
Water inlet filter