Prior To Commissioning - diversey TASKI vacumat 12 Manual De Instrucciones

Prior to commissioning

Wet vacuuming with vacumat 12/22/22T
• Pull the snap handle [1] upwards and
2
lift off the vacuum lid.
1
Check that the float housing is properly mounted and the ma-
chine is ready for the correct cleaning method, if not:
• Remove the insert for dry vacuuming and the double-filter
paper sack.
• Remove any residual dirt from the tank.
• Insert the float housing back into place.
The arrow has to point towards the intake.
• Insert the cam of the vacuum lid into
the corresponding guide and press
the snap handle down until it locks
2
1
with an audible click.
• Assemble the wet suction set.
• Attach the suction hose (squeegee) to the intake.
Additional instructions for wet vacuuming with vacumat 22T
• Fit the bumper into the end of the
1
pipe on the tilting chassis and tighten
the star screws.
2
• Push the Fixomat squeegee holder
into the specified opening and latch it
into place.
2
The Fixomat squeegee is in the park
1
ing position.
• Loosen the fixation screws on the
squeegee, mount the squeegee and
tighten the screws again.
The fixation screws must be posi
tioned above the squeegee holder.
• Attach the suction hose (squeegee) to the intake.
• Lift and push the Fixomat squeegee
3
holder towards the tank as far as it
will go and lower the Fixomat squee-
gee. Use the screw [3] to adjust the
squeegee to the floor.
The Fixomat squeegee is in the
working position.
2
1
Dry vacuuming
Attention:
This machine must never be operated
without the double-filter paper bag!
Attention:
This machine must never be operated
without the filter cloth.
Notice:
The Fixomat squeegee is unsuitable for
dry suction use.
Notice:
You can find the accessories for dry vacu-
uming on page 74 of these Instructions of
use.
2
1
• Remove the wet vacuuming insert.
• Remove any residual dirt from the tank.
• Clean the tank with water and leave it to dry.
2
1
-
• Assemble the dry vacuuming set.
• Attach the suction hose to the intake.
Application technique
-
Machine
Wet cleaning
Dry cleaning
Cleaning parquet and laminate
floors
• Pull the snap handle [1] upwards and
lift off the vacuum lid.
• Pull the double-filter paper bag over
the intake.
The rubber flange of the double-filter
paper bag must be behind the cam of
the intake!
• Insert the filter basket.
The arrow has to point towards the
intake.
• Insert the cam of the vacuum lid into
the corresponding guide and press
the snap handle down until it locks
with an audible click.
vacumat 12/22/22T
Yes
Yes
No
EN
69