Beginning Work With The Machine; Conclusion Operation - diversey TASKI vacumat 12 Manual De Instrucciones

Beginning work with the machine

Dry and wet vacuuming
Attention:
Do not vacuum objects such as screws
and other metal parts or objects that may
cause damage to the machine!
• Connect the plug to the mains socket and press the ON/
OFF switch.
Attention:
When the nominal consumption is reached
while wet vacuuming, the float will cut off
the air suction.
No more liquid will be vacuumed and the
machine must be turned off and emptied.
Notice:
If residue remains after wet vacuuming us-
ing vacumat 22T, you can adjust the
height using the vertical adjustment screw
of the Fixomat squeegee.

Conclusion operation

Wet vacuuming
Wet vacuuming with vacumat 12/22
The soiled solution that has been picked up must be disposed
of in compliance with the national regulations.
• Press the locking device on the intake and remove the suc-
tion hose.
• Pull the snap handle [1] upwards and
2
lift off the vacuum lid.
1
• Remove the coarse filter (black) and wash it out under run-
ning water.
Notice:
The float insert must be maintained after
every use (page 70).
Wet vacuuming with vacumat 22T
• Lift and push the Fixomat squeegee
holder to the next opening and lower
the Fixomat squeegee.
The Fixomat squeegee is in the park
ing position.
2
1
• Press the locking device and remove the suction hose from
the intake and the Fixomat squeegee.
• Loosen the fixation knobs on the squeegee.
• Remove the squeegee and tighten the screws.
• Clean the Fixomat squeegee with water using a brush.
70
Tilt function
Carry function
• Rinse the tank.
Dry vacuuming
2
1
Notice:
The soiled solution that has been picked
up must be disposed of in compliance with
the national regulations.
Attention:
The machine may only be used with a fully
functioning filter cloth!
Replace heavily worn or defective filter
cloths.
-
• Hold the chassis and slowly tilt the
tank to empty.
• Push the levers that connect the tub
to the tilting frame outwards.
• You will now be able to lift the tank
from the frame and empty it.
• Pull the snap handle [1] upwards and
lift off the vacuum lid.
• Remove the filter basket, check the
filter cloth for soiling and, if neces-
sary, clean it.