Fagor 8H-290AB Manual De Instrucciones página 49

OPERATION
exception is the pyrolytic cleaning function,
which cannot be modified.
Timed operation
In this mode the oven will turn off after a set
duration. You can set the duration from 1
minute to 10 hours. To set timed operation
for any oven function, touch and hold the
sensor, and the
the display. Touch the
display will show the
• Set the Duration by turning the +/– knob
(clockwise), then touch
• Adjust the Duration as need using the
+/– knob (in either direction). Touch
to confirm the adjusted setting.
• To cancel timed operation use the +/–
knob to adjust duration down to
touch to confirm.
Timed operation will interrupt the active oven
function. When the set Duration has elapsed,
you will hear beeping. Touch any sensor or
open the door to mute the beeping. When
the beeping is muted the appliance will go
into stanby.
Delayed timed operation
You can set the oven to start at a specific time
and operate for a set Duration. You can delay
the oven start from 1 minute to 23 hours 59
minutes, and set the Duration for up to 10
hours. To activate the delayed timed opera-
tion, first set the timed operation. Then touch
and hold the sensor again and the timer
symbol will flash on the display. Touch the
sensor twice, and the
on the display. Now you can:
Use the +/– knob (clockwise) to set the time
when oven needs to start, then touch
confirm.
Adjust the time as needed using the +/– knob
timer symbol flashes in
sensor again, the
symbol. Now you can:
to confirm.
pictogram will flash
(in either direction). Touch
adjusted setting.
To cancel timed operation use the +/– knob
to adjust duration down to
to confirm.
Timed operation will interrupt the active oven
function. When the set Duration has elapsed,
you will hear beeping. Touch any sensor or
open the door to mute the beeping. When
the beeping is muted the appliance will go
into stanby.
Meat probe
You can connect the meat probe* at any
time. When you connect the meat probe, two
temperatures will be shown on the display.
and
Current meat probe temperature is shown on
the left and the set temperature on the right.
When you connect the meat probe, the set
temperature is flashing and you can adjust it
using the +/– knob. Touch to confirm or sim-
ply wait 5 seconds. When the meat probe is
connected and the set temperature has been
reached, the appliance will go into standby
and you will hear beeping. Touch any sen-
sor to mute the beeping or use the +/– knob
clockwise to adjust the temperature. If you
unplug the meat probe during any function,
the appliance will go into standby.
Note: Time operation and delayed timed
operation cannot be used together with the
meat probe. If you pug in the meat probe,
the timed operation will be cancelled. The
set temperature inside the oven cavity and
the set function are not affected.
* depending on model
to
to confirm the
and touch
49