Fagor 8H-290AB Manual De Instrucciones página 51

OPERATION
Note: Do not set the function selector knob
to "0", i.e off position.
All pre-set programmes can be freely modi-
fied – you can adjust temperature or duration.
To do this, follow the relevant instructions
("Preview and modify settings during oven
operation" and "Timed operation"). When you
make any adjustments, the stored pre-set
programme is not affected and the original
settings will be restored the next time you
select a pre-set programme.
Note: To cancel a pre-set programme im-
mediately after you se it with the
you need to first turn the function selector
knob to the required function and let the ap-
pliance to start the programme, if only for a
few seconds. When the
you can turn the function selector knob to "0".
If attempt to use a pre-set programme when
the meat probe is plugged in, you will hear a
beep to remind you to unplug the meat probe.
The appliance will start when you unplug the
meat probe and close the oven door.
Pre-set programmes with quick pre-heat
Some pre-set programmes require the oven
to be pre-heated. They are marked accord-
ingly in the above table. When you select
a pre-set programme with pre-heating, the
quick pre-heat pictogram will be displayed.
When the pre-heat temperature is reached
you will hear beeping and the ":07" number
and the pictogram will fash by the pre-set
programme number.Open the door and the
pictogramm will be off. Place the dish in
the oven and close the door. Turn the func-
tion selector knob to the heating function
corresponding to the flashing number — the
number will be off and the appliance will start.
Note: It is inadvisable to modify a pre-set
sensor
pictogram is show
programme during the quick pre-heat phase
as this will cancel the pre-set programme and
the appliance will operate with the currently
set function, duration and temperature.
End a pre-set programme.
When a pre-set programme ends, you will
hear beeping.
Oven door
Oven door must be closed during operation.
When you open the door you will interrupt
the active oven function. If the door remains
open for more than 30 seconds, an acoustic
signal will sound to prompt you to close the
oven door. Touch any sensor or close the
oven door to mute the beeping.
If you open the door for less than 10 minutes
the active settings are unaffected. For safety
reasons, after this time, the oven enters the
standby mode (all settings are cleared).
Limit the oven operating time
For safety reasons, the oven operation is time
limited. If the set temperature is up to 100°C,
the oven will enter the Standby mode after 10
hours, and if the set temperature is 200°C and
more, the oven operation is limited to 3 hours.
In the temperature range of 101°C to 199°C,
the operation time is limited proportionally
between 3 and 10 hours.
Quick pre-heat
In order to quickly pre-heat the oven, the
fan, fan heater and the roaster are on, and
the appliance operates at it maximum power
of 3.6 kW.
51