Chicco ALYSIA Manual De Instrucciones página 15

Ocultar thumbs Ver también para ALYSIA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
BUCKLES FOR CAR SEAT BELTS
18. To fasten the two buckles to the pins located on the ends
of the carry cot (Fig. 18A), insert each buckle in the re-
spective pin, first pushing on the buckle (Fig. 18B) then
pulling the buckle down until you hear a click (Fig. 18C).
WARNING: Do not assemble the buckles backwards! (Fig.
18D). The carry cot is now ready to be positioned in the car.
FASTENING THE CARRY COT IN THE CAR
19. To fasten the carry cot to the rear seat, position it at the
centre, aligned with the car seat, and fasten it using the
seat belts of the two outer seats (Fig. 19).
20. If the rear seat of your car has a 3-point seat belt in the
middle seat too, the carry cot can also be fastened to
one side using the middle seat and lateral seat, fasten-
ing it with the seat belts of these two seats (Fig. 20).
21. Pull and fasten the two seat belts in the seat's buckles
(Fig. 21). Recline the carry cot backrest completely
WARNING: Never use the carry cot in the car with the
backrest raised! Safety is not guaranteed! Follow the steps
below on both sides:
22. Take the seat belt and make a loop (Fig. 22);
23. Take the car kit buckle and rotate the red bar of the
buckle outward (Fig. 23).
24. Insert the loop you've made with the seat belt into the
buckle (Fig. 24A – 24B) and rotate the red bar to its initial
position so that it rests inside the loop (Fig. 24C).
25. Pull the seat belt toward the retractor pressing the carry
cot against the seat so that it is fastened well (Fig. 25A).
WARNING: Make sure that the carry cot is fitted against the
backrest and seat.
WARNING: Make sure that the belts are tensioned (Fig. 25B).
REMOVING THE CARRY COT FROM THE CAR SEAT
Follow the steps below on both sides of the carry cot.
26. Unfasten the buckle from the carry cot pulling the buck-
le's red tab outward and pushing (Fig. 26) to release the
carry cot from the seat belt. The buckle is left fastened
to the seat belt.
WARNING: Never use the seat belt to fasten a passenger
without removing the CAR KIT buckle: it can be dangerous!
27. To remove the buckle from the belt, loosen the loop in
the belt (Fig. 27A) and rotate the red bar so that it comes
out (Fig. 27B).
FASTENING THE CARRY COT TO THE STROLLER
Prepare the stroller to assemble the carry cot according to
the stroller's instructions.
For use with the stroller, make sure to remove the safety
harnesses by reversing the order of the steps in the Carry
cot SAFETY HARNESSES AND COMFORT KIT section.
WARNING: The carrycot should only be installed rearward
facing.
WARNING: The restraint system must be removed when
the product is used outside the car.
WARNING: To fasten the carry cot to the stroller structure,
remove the seat first.
28. Hold the handle in carrying position (vertical) and posi-
tion the carry cot in the vertical joints until you hear the
click confirming fastening. Place the carry cot with the
foot zone turned towards the stroller handle (Fig. 28A).
WARNING: Before using, make sure that the carry cot is
properly locked on by pulling on it upwards.
REMOVING THE CARRY COT FROM THE STROLLER
29. Position the handle in the carrying position (vertical),
pull the button on the front of the carry cot outward
(Fig. 29A) and, keeping the button raised, remove the
carry cot from the stroller structure by pulling it up (Fig.
29B).
WARNING: The fastening and releasing operations can be
carried out also with your child inside the carry cot; howev-
er, these operations may be more difficult to execute due
to the child's weight. Pay attention when carrying out the
aforementioned operations.
Important Note: The images and instructions in this man-
ual refer to a single carry cot version. Some of the compo-
nents and functions described here may vary depending
on the model purchased.
WARRANTY
The product is guaranteed against any conformity defect
in normal conditions of use as provided for by the instruc-
tions. The warranty shall not therefore apply in the case
of damage caused by improper use, wear or accidental
events. For the duration of the warranty on conformity de-
fects please refer to the specific provisions of national laws
applicable in the country of purchase.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido