Trueshopping JSG3IN1BC Manual Del Usuario página 3

USB POWERED DEVICES
1. Prior to connecting the device to the USB port of this unit, make sure the device is OFF ( 0 ).
2. Using the interface cable included with the device to be powered or charged, connect the device to the USB port on the Portable Power Source.
3. Press the USB Port power switch to the ON ( I ) position. (The device with built-in battery will start charging automatically). Turn ON the device and use as normal.
UNIT BATTERY HAND GENERATOR INSTRUCTIONS:
IMPORTANT: Prior to charging the Portable Power Source unit battery using the hand generator, make sure that the unit power switches are in the OFF positions.
1. Place the unit in a dry open flat area with overhead cover.
2. Using either hand, securely grasp the Portable Power Source carrying handle.
3. With the free hand, securely grasp the Hand Generator Pull Handle.
4. To generate unit battery crank charging, firmly pull-up on the Hand Generator Pull Handle while holding down the Portable Power Source.
NOTE: DO NOT exceed the hand generator pull handle maximum cord length of 30 inches.
5. Allow the Hand Generator Pull Handle cord to retract back into the Portable Power Source housing, thereby completing one (1) generator crank cycle.
6. Continue Hand Generator cranking cycles for a minimum period of 3 minutes.
7. The Portable Power Source internal battery will achieve a charging level adequate enough for one (1) vehicle battery boost charge.
NOTE: the Portable Power Source unit battery charge level will vary pending the unit battery status at time of crank charge. User may have to continue unit hand
generator crank cycles until the Portable Power Source unit battery reaches the charge level adequate for jump starting (battery boosting) a vehicle.
SPECIFICATIONS:
1. BUILT IN BATTERY .......................9 AMP HOUR (AH) SEALED LEAD ACID, MAINTENANCE FREE, SPILL-PROOF, RECHARGEABLE
2. DC SOCKET ..............................12 VOLT DC / 10 AMP
3. USB PORT ..................................5 VOLT DC / 2100 mA
4. LED LIGHT ..................................12 VOLT DC/100Ma
5. AIR COMPRESSOR ...................260 PSI
6. CIRCUIT BREAKER .....................10 AMP INTERNAL, WITH AUTOMATIC RESET
7. UNIT DIMENSIONS.....................8.8 in. ( H ) x 6.7 in. ( W ) x 11.5 in. ( D )
8. STORAGE TEMPERATURE....... ....STORE IN COOL, DRY, WELL VENTILATED AREA WITH OVERHEAD COVER
STORAGE:
This unit may be stored in any position. ENSURE that the booster clamps are secured to their storage holders.
CAUTION:
The Portable Power Source switches must be in the OFF positions. Store at room temperature. If not used for prolonged time Recharge every 2 months in the
winter & monthly in summer.
FEATURES:
A. BOOSTER CABLES POWER SWITCH: Heavy Duty Rotary Switch turns power OFF to booster cables when not in use. Power can be turned ON by turning the rotary switch
in the clockwise direction.
B. POWER STATUS & CHARGE INDICATOR: Red LED: Battery charging, Amber LED: Battery charged at 75%, Green LED: Battery is fully charged.
C. HAND GENERATOR: Manually charges battery in remote areas.
D. HAND GENERATOR CHARGE INDICATOR: LED indicator illuminates when battery is being charged.
E. CONVENIENT CHARGE CORDS: 120 Volt AC charger for in home use & 12 Volt DC charger for on the road use.
F. 12 VOLT DC POWER OUTLET WITH OVERLOAD PROTECTION: Provides power to most 12 Volt DC accessories equipped with a 12 Volt DC accessory plug. Portable Power
Source circuit is protected with a 10 AMP auto-reset overload circuit breaker.
G. HEAVY-DUTY BOOSTER CLAMPS: 200 AMP RATED color-coded battery clamps.
H. PROFESSIONAL QUALITY CABLES: Colour coded cables with extra thick oil resistant external cable insulation sheathing.
I. BOOSTER CLAMPS STORAGE HOLDERS: Prevents accidental sparking when cables are not in use.
J. REVERSE BATTERY POLARITY DETECTION CIRCUITRY: Circuitry automatically activates if accidental reverse polarity clamp connection occurs, RED LED illuminates
accompanied by high pitch alarm. Conveniently and rapidly inflates most inflatables.
K. BUILT-IN POWERFUL 260 PSI COMPRESSOR:
a. Compressor Power Switch: Compressor and power can be switched ON or OFF.
b. Air Pressure Gauge: Accurate air pressure dial gauge with large and easy to read pressure increments.
c. Heavy Duty High Pressure Inflator Air Hose: Professional high pressure rubber hose. Equipped with a universal air valve stem Quick - Connector Nozzle.
d. Nozzle Adaptors for Inflatables
L. STANDARD 5 VOLT USB PORT: For devices that require power from a standard USB port.(Switch Activated - Inverter & USB Port Power Switch - located on front panel).
M. LED LIGHT: Provides long lasting portable lighting with emergency flasher function.
Compressor Power Switch
OFF
ON
Nozzle Adaptors for Inflatables
convert small diameter air valve stem to
regular size air valve stem.
To inflate balls
Air Pressure Gauge
Adaptor for pool
To
air mattresses,
rubber rafts, pool,
beds, & balls.