Kohler K-110 Guia De Instalacion página 10

Ocultar thumbs Ver también para K-110:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Turn the support bolt
couterclockwise
Setscrew
to unthread.
Washer
Flanged Union
Nut
7. Wall-Mount Faucet Installation
Verify that thread sealant has been applied to the threads of the
plated elbows. If not, apply thread sealant at this time.
Slide a nut onto one of the plated elbows. Be careful to avoid
scratching the plated finish.
Thread the flanged union onto the plated elbow. Verify that the
flanged union is level.
Set the washer on top of the flanged union.
Repeat for the other plated elbow.
Set the spout assembly on both washers.
Thread the nuts up onto the spout assembly to secure it to the
plated elbows.
NOTE: Make sure the faucet is installed parallel with the finished
wall. Do not force the faucet when installing the support bolt into
the cradle.
Unthread the support bolt until it enters the hole in the back of
the cradle.
Secure the support bolt in place with the setscrew.
1008209-2-H
Cradle
Spout
Assembly
Plated Elbow
10
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-331K-6905K-16210

Tabla de contenido