Kohler K-110 Guia De Instalacion página 12

Bonnet
Stem
Extension
9. Oval Handle Installation
NOTICE: Risk of product damage. Do not overtighten.
Overtightening will damage the handle.
Verify that the valves are in the closed position.
Insert the stem screw into the stem extension and tighten with a
screwdriver.
Place the ceramic insert into the handle.
Secure the insert with the handle screw. Do not overtighten.
Loosen the setscrew.
Position the handle assembly on the stem extension.
Verify that the handle is in an even horizontal position. If needed,
remove the handle and adjust its position on the splines of the
stem extension until horizontal. For fine adjustment, pull out the
stem extension until it disengages from the valve, rotate, and
return it to its original position. Do not pull the stem extension
completely out.
Tighten the setscrew.
Repeat for the other handle.
1008209-2-H
Setscrew
Stem
Screw
Handle
Handle
Screw
Hot
Open
Shown In Closed Position
12
Ceramic Insert
Cold
Open
Kohler Co.