Lift Identification And Pictograms Description; Intended Use - CLAS PE 2008 Manual De Instrucciones

PE 2008

3.5 LIFT IDENTIFICATION AND PICTOGRAMS DESCRIPTION

The safety signals (Fig. 5) described in this manual are applied onto the lift (Fig. 6), and
warn about unsafe and hazardous situations. Decals shall be kept clean and, if detached
or damaged, they shall be immediately changed.
Carefully read the meaning of the safety signals, and memorise it:
1 Instructions plate
Manufacturer's logo
3
4 Max. load
Carriage alignment
5
6 Plaquette CE
A Serial No.
B Type
C Model
D Max. Load
E Ground
F Manuf.year
G Voltage
Each lift is supplied with the identification plates (6, Fig.5) relating to the different versions. Data
(A) and (B) have always to be mentioned for any service and spare parts need.
WARNING: Once the assembly has been carried out, the operator should apply the
identification plate, according to the installed lift version, onto its proper position
(6, Fig. 6).

3.6 INTENDED USE

The vehicle lifts described in this manual are designed and manufactured for lifting vehicles for
inspection, maintenance and/or repair purposes only.
The vehicle lift should be used only for lifting vehicles within the load capacity limits given in the
IDENTIFICATION PLATE (6, Fig. 5) and in the paragraph 1.3 «LOAD DISTRIBUTION» (Fig. 3).
66
PE 2003 PE 2009
H TFreq.
I Power
L Pressure
M Absorption
BEFORE USING THE LIFT BRIDGE, READ THE CONTENTS OF THIS
MANUAL CAREFULLY.
7 Column greasing
8 Danger signal. Voltage on.
9 Danger signal. Risk of feet shearing.
10 Danger signal. Fall possibility. Do not get
up on the runways
11 Danger signal. Before carrying out
any maintenance operation, stop the
equipment and consult the user's manual
12 Safety device
13 Load distribution
14 Vertical logo