Mono/Stereo Setting; Menu; Adjust Tone/Eq; Set The Clock; Turn Off The Display - Tivoli Audio 10 Manual Del Propietário

English
9. pq/TUNE +/-: Press to adjust menu items. Use these same buttons to manually tune up or
down when in FM or AM mode. Press and hold to move quickly through the frequencies. A "T"
will show on the display to indicate manual tuning mode. It will take 2 or 3 seconds until the
frequencies begin to change. Press for 1.5 seconds and release to auto scan to the next station
detected. The display will show "
scanning in AM.
10.  : Press to navigate back or forward through the menu.
11. MENU/SELECT: Press to enter the main menu and press to select items within the menu. For
more, see the section marked "Menu". Some of the menu items can be accessed regardless
of whether the Model 10 is on or off.
12. MONO: Press to change the Stereo/Mono setting. The display will show "M" for mono or "ST"
for stereo. "Mono" or "Stereo" will also be one of the fields shown when pressing the Info
button on the remote. This setting also affects the headphone output. For more, see the
section marked "FM/AM Reception".
Menu:
(Press the Menu/Select button briefly. Use the   buttons to navigate through the menu pages
and the pq buttons to change the items within the menu.)
1. TREBLE: Use pq to adjust the treble and press Select to proceed to the next menu item.
2. BASS: Use pq to adjust the bass and press Select to proceed to the next menu item.
3. BALANCE: As the balance control has no effect when the Model 10 is set to Mono, this
setting should remain in the center position, except when the optional Model 10 Speaker is
connected and Stereo mode is selected via the remote control's "Mono" button. Though we
still recommend the center balance setting in Stereo mode, you may use the pq buttons to
adjust the balance to your liking, and press the Select button.
4. EQ: The equalizer acts as a Loudness control at low volume levels. Use pq to select between
having the EQ on, having the EQ always off, or the EQ off until the Model 10 is turned off (when
it is turned on again the EQ will be on again). Press Select to proceed to the next menu item.
5. DISPLAy OFF: Use the pq and Select buttons to set the display on or off. Setting the display off
will turn the backlight off when the Model 10 is turned off. This may be desirable when sleeping.
While the display is off, pressing a button on the remote will turn the display on for 10 seconds.
6. BACkLIGHT: Use pq to make the backlight brighter or dimmer.
7. CONTRAST: Use pq to increase or decrease the display contrast.
8. CLOCk SET: Use pq to set/change the hour, then press Select. Repeat this process to set/
change the minutes, then press Select to proceed to the next menu item. Use pq to set the
year and press Select to proceed to the next menu item. Use pq to set the month and press
Select to proceed to the next menu item. Use pq to set the day and press Select to complete
the process and return to the source screen.
10
" when auto scanning in FM and " " when auto