Remote Control - Tivoli Audio 10 Manual Del Propietário

TV, connect said device's audio output to this stereo input and change the source to Auxiliary.
This stereo input accepts a 3.5mm stereo male mini connector. Note you may need to adjust
the volume level differently for an auxiliary device than the level used for radio listening.
10. POWER CORD INPUT: Firmly insert the included power cord. When unplugging the power
cord from the wall outlet, always grasp it by the plug and not the cord. We recommend the
use of a power strip with surge protection. Be sure your region's voltage is consistent with the
voltage indicated on the rear panel under the power cord input. Tivoli Audio is not responsible
for damaged caused by incorrect voltage.
Guide to Features (Remote Control):
1. POWER: Press briefly to power the Model 10 on. The radio will power on to the last source
used. Press to power the Model 10 off.
2. MUTE/SNOOZE: Press to mute the audio
(the icon will flash) while the unit is play-
ing; press again or adjust the volume to
restore sound. Press to mute the alarm
for 7 minutes after the alarm sounds. The
alarm will re-sound after 7 minutes. A
icon will show on the display when
Snooze is active. The Snooze time is
not adjustable.
3. ALARM: With the Model 10 powered on,
use the pq and Select buttons to adjust
and set the alarms. For a complete step-
by-step guide, refer to the section titled
"How to set the Alarm."
4. SLEEP: Press to start the 20 minute
sleep timer. The display will indicate the
remaining sleep time and automatically
power the radio off after 20 minutes. A
small clock face [
display when the Sleep timer is active.
Press again to cancel the sleep timer.
The amount of sleep time is not adjust-
able. Sleep can be activated regardless
of whether the Model 10 is on or off.
5. SOURCE: Press to change sources.
6. INFO: Press repeatedly to view basic settings information.
7. PRESETS 1-5: Press and hold to store the currently tuned station. Press briefly to recall the
station associated with that specific preset. The preset number will be indicated on the display.
There are 5 presets for the FM band and 5 presets for the AM band.
8. VOLUME +/–: Press the + button to raise the volume level or the – button to lower the volume
level. If the audio ever sounds distorted, lower the volume level to avoid damaging the speaker.
Adjusting the volume while the Model 10 is muted will cancel the muting.
] will show on the
4
2
3
11
8
English
5
1
6
7
9
12
MONO
10
9