Simu AUTOSUN 2 T3.5 EHz DC Manual Del Usuario página 13

4 MOTOR STAND BY / WAKE UP
i
It is possible to put the motor in stand by (radio de-activated) to:
- limit the battery discharge when the solar panel is unable to operate normally (packaging of the roller
shutter, transport, storage,...)
- eliminate any risk of random use (packaging of the roller shutter, transport).
After installation of the roller shutter, normal operation will be restored by woken up the motor
(radio re-activated).
4.1 Motor's radio Stand-by :
i It is only possible to put the motor in standby after programming the first control point in §3 and before
performing the programming of the § 5 (for 10 min max.) or during the 10 min following a simultaneously
power cut from the battery and from the solar panel).
- Press simultaneously and for 3 seconds the "UP" / "STOP"
and "DOWN" buttons from transmitter (programmed in §3), the
motor will run for 0.5 second in one direction and then in the
other direction. The motor's radio is de-activated.
4.2 Motor's radio wake up:
i Wake up is only possible if the solar panel is connected to the motor and illumated (diffuse sun light,
flashlight,...at minimum).
- Press simultaneously and for more than 10 seconds the "UP"
and "DOWN" buttons of the programmed transmitter. The motor will
run for 0.5 second in one direction and then in the other direction.
The motor's radio is waked up. The motor work now normally.
5 PROGRAMMING A NEW (INDIVIDUAL, GROUP OR MAIN) CONTROL POINT
5.1- Open the memory of the receiver from the
control transmitter:
- Press the "PROG" key of the transmitter for about
3 seconds. The motor will run for 0,5 second in one
direction and then in the other.
5.2- Confirm the operation from the new transmitter
you want to program:
- Press the "PROG" key of the transmitter for 1 second.
The motor will run for 0,5 second in one direction and
then in the other..
- For group controls, repeat operations 5.1 and 5.2 for each motor in the group.
- For general controls, repeat operations 5.1 and 5.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 5.1 with a programmed transmitter,
then perform the operation 5.2 with the transmitter to be deleted.
> 3 s
1
PROG ≥ 3 s
2
PROG < 1 s
>>
>>
10 s
>>
>>
EN
5/8