Simu AUTOSUN 2 T3.5 EHz DC Manual Del Usuario página 11

2.2- Checking the rotation direction:
a
>>
Press the "UP" button of the transmitter :
a- If the motorized tube runs in the Up direction, move to next stage 2.3.
b- If the motorized tube runs in the Down direction, reverse the rotation direction by pressing the "STOP" button
for at least 3 seconds. The motor will run for 0,5 second in one direction, then in the other direction. Move to the
stage 2.3.
2.3- End limit adjustment:
The end limits of the T3.5 EHz DC are adjusted in 4 different ways depending on the following conditions : Bottom
slat stop or not, rigid* or flexible link between the rolling shaft and the shutter.
A
* V.A.R
V.A.S
Easylink
OctoEasy
A 1
B 1
1- Position the motor on the Up end limit by using the buttons "UP" or "DOWN".
2- To memorize the UP end limit position, press simultaneously the buttons "STOP" and "DOWN". The motor will
run automatically in the down direction.
3- Press the "STOP" button to immobilize the motor.
4- Press 2 seconds the "STOP" button to validate the setting. The motor will run for half a second in one
direction, then in the other direction. The operation is completed. Go to step §3.
>> OK >> 2.3
b
B
* V.A.R
V.A.S
Easylink
OctoEasy
2
2 s
2
>>
3 s
C
1- Simultaneously press the "UP" and "DOWN" buttons
of a Hz transmitter. The motor will run for 0.5 second in one
direction and then in the other.
2- Press the "STOP" button for 2 s. The motor will run
for 0.5 second in one direction and then in the other. The
operation is completed. Go to step §3.
>> >> OK >> 2.3
D
3 4
2 s
EN
3/8