Install The Wall Jambs; Apply Silicone Sealant - Kohler K-1000-H2 Guia De Instalacion

Wall
Jamb
Level
2" Stainless Steel
Flathead Screw
Footbath Locating Pin

10. Install the Wall Jambs

IMPORTANT! Leave the studs exposed. The wall jambs must be secured directly to the stud wall frame
to achieve proper support of the enclosure. Expanding wall anchors do not provide adequate support for
the door. Do not install the finished wall until instructed to do so.
NOTE: The enclosure components are identified with removable labels to assist you with component
identification.
Remove the wall jamb kit from the carton and locate the wall jambs. Leave the protective tape in
place.
Install one of the wall jambs by positioning it over the footbath locating pin. The wall jambs are
not interchangeable.
Use a level and adjust the wall jamb to be exactly plumb. Secure the wall jamb to the double stud
framing and furring strips with four 2" (5 cm) stainless steel flathead screws (provided).
Repeat for the other wall jamb.

11. Apply Silicone Sealant

CAUTION: Risk of property damage from concealed leakage. Apply silicone sealant, following the
sealant manufacturer's instructions, to ensure a watertight installation.
Apply a continuous bead of silicone sealant to the inside of the wall jamb where it contacts the
footbath, as shown.
Repeat for the other wall jamb.
Kohler Co.
Top View
Inside Of
Wall Jamb
Apply Silicone
Sealant.
11 1032118-2-D