Chopin LabMill Instalación Rápida página 4

PERFORM A FIRST TEST
A. Breaking
1. Weigh the grain (between 50 g and 3.5 kg) and
put it in the breaking hopper.
2. Select Breaking cycle 1 by clicking on the icon
and then .
3. When the cycle ends, recover the material from
drawers A, B, C, D and weigh them. Note the
weights and carefully keep each product
separate.
4. Put the material from drawer A in the breaking
hopper.
5. Select Breaking cycle 2 by clicking on the icon
and then click on
6. When the cycle ends, recover the material from
drawers A, B, C, D and weigh them. Note the
weights and carefully keep each product
separate.
B. Sizing B. Sizing
1. Put the coarse middlings recovered from breaking
operations 1 and 2 in the sizing/reduction hopper.
2. Select Sizing cycle 3 by clicking on the icon
and then click on .
3. When the cycle ends, recover the material from
drawers E, F, G and weigh them. Note the weights
and carefully keep each product separate.
Breaking cycle block diagram
(steps 1 & 2)
.
Sizing cycle block diagram (step 3)
1
3
1
3
2
4
2