Solo 452 Manual Original. Manual Del Usario página 25

11. Filling
When handling the spraying agents, always follow
the safety instructions of these operating
instructions (pay special attention to section 4.6)
and the information provided by the manufacturer
of the particular spraying agent.
Spraying agent volume:
Mix the spraying agents according to the
instructions provided by the manufacturer of the
spraying agent. Choose the appropriate volume
according to requirements.
Mixing spraying agents:
Only mix spraying agents out in the open. Never
do this inside living spaces, stables or in storage
spaces that are used for food or animal feed.
Never mix the spraying agent directly in the
spraying agent tank.
Spraying agents in powder form:
 Mix the spraying agent in a separate container,
not in the spraying agent tank.
 Ensure that the mixture is thoroughly mixed
before pouring it into the spraying agent tank.
Liquid spraying agents:
 Fill 1/4 of the spraying agent tank with clean
water.
 Then pre-mix the spraying agent with clean
water in a separate container according to the
instructions provided by the manufacturer of the
spraying agent.
 Pour the pre-mixed spraying agent into the
spraying agent tank.
 Top up with the required amount of clean water
according to the manufacturer's instructions.
When using spraying agents that have been mixed
from herbal preparations, the liquid needs to be
pre-filtered.
For filling the equipment, always use the strainer
inside the filler neck and observe the filler area
through the filling process.
The strainer has a mesh size of 0.55 mm. Only
use original SOLO strainers, part no.: 13279 with
standard mesh size.
Avoid any direct contact of the filling hose and the
contents of the spraying agent tank.
Fill level markings are applied to the side of the
spraying agent tank .
When filling up the tank, ensure that you do not fill
above the top marking (maximum fill volume).
Never allow the spraying agent tank to overflow or
public bodies of water, rainwater drains or sewage
drains to become contaminated.
Immediately wipe up any spilled spraying agent.
CAUTION:
Never fill different spraying agents into the
spraying agent tank without first thoroughly
cleaning the tank and all parts that come into
contact with the spraying agent and flushing the
system with plenty of clean water.
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).
Filling
Identification of the tank
contents:
Attach the relevant
sticker to the spraying
agent tank to indicate the
contents of the tank (i.e.,
herbicide, fungicide or
insecticide).
The designation of the
spraying agent used has
to be attached to the
device and has to be
updated every time when
the spraying agent is
changed.
ENGLISH 9