Yamato HCM 650 Manual Del Usuario página 24

When you are completely satisfied with the condition of your shipment,
inventory the contents.
1. To attach Wheels (68) to Wheel Bracket (70), slide a Flat Washer (67),
Wheel and second Flat Washer onto each end of Bracket axle;
Insert a Cotter Pin (69) through holes in each end of the Bracket axle and
bend the Cotter Pins over to secure the Wheels in place. Figure 1
Wheel(68)
Flat Washer(65)
Cotter Pin(69)
2. Place the Stand (66) into the Wheel Bracket (70) so that the bolt holes line
up. Fasten together using Bolts M8x65,M8x55(5,4), Flat Washers (3) and
Nuts M8 (6). Tighten with a wrench (not included) until secure;
Insert Leg (1) into Stand so that holes line up. Fasten together using Bolts
M8x65,M8x55(5,4), Flat Washers (3) and Nuts M8(6). Tighten with a
wrench until secure;
Place Stand upright. Figure 2
Assembly Instructions
Wheel Bracket(70)