Yamato HCM 650 Manual Del Usuario página 30

Cleaning, Maintenance, and Lubrication
1. Before each use, inspect the general condition of the tool. Check for loose
hardware, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, damaged or cracked belts, and any other
condition that may affect its safe operation.
2. After use, immediately wash out all debris from the inside and outside of the
Cement Mixer. Make sure the Power Cord is disconnected.
3. Do not apply water in or around the Motor Base Cover.
4. Periodically recheck all nuts, bolts, and screws for tightness.
5. When not in use, locate the Mini Cement Mixer in a safe, secure area that
has no child accessibility.
6. Since all bearings are shielded and permanently lubricated, simply leave
them alone until they need to be replaced. Do not lubricate them.
1. Retighten belt after the first 25 hours of use. To test the tension, follow the
steps below.
2. Remove belt cover.
3. Examine belt for cracks, tears in the backing, or other damage. Replace
belt if damaged according to steps below:
A. Loosen the motor bracket bolts and slide the bracket up as far as
possible.
B. Slide the old belt off of the larger pulley first, then remove it from the
motor pulley.
C. Put the new belt around the small pulley first, then around the large
pulley.
D. Move the motor bracket down the belt until it is properly tensioned
according to the directions below. Tighten the motor bracket bolts.
4. Check and adjust belt tension according to the steps below:
SECTION 5:MAINTENANCE
Belt Inspection and Tensioning