Yamato HCM 650 Manual Del Usuario página 29

10. Check all connections to verify that all screws, nuts, and bolts are securely
tightened.
SECTION 4: OPERATIONS INSTRUCTIONS
1. Designate a work area that is clean and wet-lit. The work area must not
allow access by children or pets to prevent distraction and injury.
2. Route the power cord along a safe path to reach the work area without
creating s tripping hazard or exposing the power cord to possible damage.
The power cord must reach the work area with enough extra length to allow
free movement while working.
1. Place the Cement Mixer on a solid, even surface.
2. Connect the Power Cord to en electrical outlet (or properly rated extension
cord) with a three prong receptacle.
3. Add material to the Drum. Typical maximum mixing quantities include:3/4
gallons water, 1 shovel cement, 5 shovels aggregate rook using a size 3
shovel.
WARNING! Do not attempt to move the Cement Mixer when it is full
and/or in operation. It is unsafe to move the mixer while in this condition,
and severe injury to personnel could occur.
4. Adjust the drum angle by pulling out on the Degree Adjusting Arm (),
Disengaging the locking pins, and push on Arm until the desired angle is
reached. Re-engage the locking pins.
5. Flip the switch (54) to the (I) or On position.
6. Filling and emptying the Drum is best done with the Drum Rotating.
CAUTION! Never leave the Cement Mixer running while unattended. Do
not turn Mixer Off while full of cement.
7. When finished, flip the Switch to the (O) or Off position, and disconnect the
Power cord.
8. Turn the Drum angle as far down as possible to drain all fluids from Drum.
9. Clean, then store indoors and out of children's reach.
Work Piece and Work Area Set Up
General Operating Instructions